Ruckus: Difference between revisions

From Dave-Wiki
Jump to navigation Jump to search
No edit summary
Line 7: Line 7:
===Determine port of MAC===
===Determine port of MAC===


<code>sh mac-address | inc 5916</code>
  sh mac-address | inc 5916


Output:
Output:


<code>3817.c3ca.5916 11 Dynamic 277</code>
  3817.c3ca.5916 11 Dynamic 277


===Show detailed LLDP===
===Show detailed LLDP===


<code>sh lldp neigh detail ports e 11</code>
  sh lldp neigh detail ports e 11


Output:
Output:
Line 40: Line 40:
; MONITOR Port: the port you want to capture traffic from (e.g., 1/1/3 below)
; MONITOR Port: the port you want to capture traffic from (e.g., 1/1/3 below)


<code>(config)# mirror-port ethernet 1/1/5</code>
  (config)# mirror-port ethernet 1/1/5
 
  (config)# interface e 1/1/3
<code>(config)# interface e 1/1/3</code>
  (config-if-e1000-1/1/3)# monitor ethernet 1/1/5 both
 
<code>(config-if-e1000-1/1/3)# monitor ethernet 1/1/5 both</code>


=Security=
=Security=


2020-06-07 - Some good info to hold you over: http://www.netadmin.us/docs/TACACS-RADIUS.pdf
2020-06-07 - Some good info to hold you over: http://www.netadmin.us/docs/TACACS-RADIUS.pdf

Revision as of 19:00, 17 February 2024

General

Show List of Interfaces

 sh int brief

Determine port of MAC

 sh mac-address | inc 5916

Output:

 3817.c3ca.5916 11 Dynamic 277

Show detailed LLDP

 sh lldp neigh detail ports e 11

Output:

 Local port: 11
   Neighbor: 78a6.e109.ddd1, TTL 114 seconds
     + Chassis ID (MAC address): 78a6.e109.dda0
     + Port ID (MAC address): 78a6.e109.ddd1
     + Time to live: 120 seconds
     + System name         : "s1-137-switch"
     + Port description    : "10GigabitEthernet1/2/1"
     + System capabilities : bridge
       Enabled capabilities: bridge
     + 802.3 MAC/PHY          : auto-negotiation supported, but disabled
       Operational MAU type   : 1000BaseSX-FD
     + Link aggregation: not capable
     + Maximum frame size: 10200 octets
     + Port VLAN ID: none
     + Management address (IPv4): 10.0.0.29

Span/Mirror Port

MIRROR Port
the port in which Wireshark is connected (e.g., 1/1/5 below)
MONITOR Port
the port you want to capture traffic from (e.g., 1/1/3 below)
 (config)# mirror-port ethernet 1/1/5
 (config)# interface e 1/1/3
 (config-if-e1000-1/1/3)# monitor ethernet 1/1/5 both

Security

2020-06-07 - Some good info to hold you over: http://www.netadmin.us/docs/TACACS-RADIUS.pdf