From Dave-Wiki
Jump to navigation Jump to search


Firstly, David Ellis has a site with some very useful Brocade/Ruckus ICX guides, tips, etc:

Show Management IP

 sh ip

Show List of Interfaces

 sh int brief

Show Interface DOM Info

First, ensure optical-monitoring is enabled:

 (config)# optical-monitor 1

After a while, you should be able to see DOM info, if the optic supports it:

 sh optic 1/3/1

Determine port of MAC

 sh mac-address | inc 5916


 3817.c3ca.5916 11 Dynamic 277

Show detailed LLDP

 sh lldp neigh detail ports e 11


 Local port: 11
   Neighbor: 78a6.e109.ddd1, TTL 114 seconds
     + Chassis ID (MAC address): 78a6.e109.dda0
     + Port ID (MAC address): 78a6.e109.ddd1
     + Time to live: 120 seconds
     + System name         : "s1-137-switch"
     + Port description    : "10GigabitEthernet1/2/1"
     + System capabilities : bridge
       Enabled capabilities: bridge
     + 802.3 MAC/PHY          : auto-negotiation supported, but disabled
       Operational MAU type   : 1000BaseSX-FD
     + Link aggregation: not capable
     + Maximum frame size: 10200 octets
     + Port VLAN ID: none
     + Management address (IPv4):

Span/Mirror Port

the port in which Wireshark is connected (e.g., 1/1/5 below)
the port you want to capture traffic from (e.g., 1/1/3 below)
 (config)# mirror-port ethernet 1/1/5
 (config)# interface e 1/1/3
 (config-if-e1000-1/1/3)# monitor ethernet 1/1/5 both


2020-06-07 - Some good info to hold you over: