Ruckus

General

Determine port of MAC

sh mac-address | inc 5916

Output:

3817.c3ca.5916 11 Dynamic 277

Show detailed LLDP

sh lldp neigh detail ports e 11

Output:

 Local port: 11
   Neighbor: 78a6.e109.ddd1, TTL 114 seconds
     + Chassis ID (MAC address): 78a6.e109.dda0
     + Port ID (MAC address): 78a6.e109.ddd1
     + Time to live: 120 seconds
     + System name         : "s1-137-switch"
     + Port description    : "10GigabitEthernet1/2/1"
     + System capabilities : bridge
       Enabled capabilities: bridge
     + 802.3 MAC/PHY          : auto-negotiation supported, but disabled
       Operational MAU type   : 1000BaseSX-FD
     + Link aggregation: not capable
     + Maximum frame size: 10200 octets
     + Port VLAN ID: none
     + Management address (IPv4): 10.0.0.29

Span/Mirror Port

MIRROR Port

the port that Wireshark is connected to (e.g., 1/1/5 below)

MONITOR Port

the port you want to capture traffic from (e.g., 1/1/3 below)

(config)# mirror-port ethernet 1/1/5

(config)# interface e 1/1/3

(config-if-e1000-1/1/3)# monitor ethernet 1/1/5 both

Security

2020-06-07 - Some good info to hold you over: http://www.netadmin.us/docs/TACACS-RADIUS.pdf